J BIMBI Dr.Dog Manual page 15

The use of this device does not replace the medical advice of a physician.
How to prepare and use the device
When using the device for the first time, make sure to clean all parts as described in
the section "Cleaning and Disinfection".
1. Open the nebulizer (9) and pour in the amount of medicine as prescribed by the
physician. Make sure not to pass the maximum level mark (Pic. 2/A).
2. Choose the most suitable inhalation accessory, as prescribed by the physician
(Pic. 2/B).
3. Connect the nebulizer to the compressor using the air tube (Pic. 2/C) and plug
in the power cord in an electric outlet making sure that the supply voltage is in
compliance with what is stated in this manual or the device nameplate.
4. Press the ON/OFF (1) button to turn on the device. Place the mouthpiece in the
mouth (8), let the nose piece rest (10) under the nostrils or the mask (6 or 7) on the
face making sure to cover mouth and nose.
5. Sit in a relaxed position with the upper body straight.
Do not lie down while inhaling.
6. After having completed the therapy session as recommended by the physician,
press the ON/OFF (1) button to turn off the device and unplug the power cord from
the electric outlet.
7. Make sure that the air tube contains no condensation. In case of condensation,
switch on the device to dry up any moisture in the tube and then disconnect it as
described above.
8. Empty out the remaining medicine from the nebulizer and clean the device in all
of its parts, as described in the section "Cleaning and Disinfection".
This device has been designed to operate continuously.
Do not cover the device with a cloth, towel, or anything else when in operation
to avoid overheating or malfunction of the device.
15