Auto Power Down (Apd); Advanced Settings - Cambridge Audio DacMagic 200M Manual

9
Note: Your device can only be paired and connected to the DacMagic 200M while the Bluetooth source is selected.
Paired LED status
Once your device is paired, below are the LED status of the type of codec that is being received.
SBC Codec is represented with a solid light.
aptX Codec is represented with a 2 seconds solid light followed by a very short light off interval.

Auto Power Down (APD)

Last updated: January 19, 2021 10:23. Revision #1040
dacmagic 200m / auto power down apd
The product will automatically switch to standby mode after inactivity of 20 minutes. To enable or disable this function, see below instruction:
Important note: Make sure that the DacMagic 200M is in the Standby state, before performing any APD functions.
APD OFF - Press and hold down the Volume knob for 5 seconds, and wait for the Input LEDs to blink 2 times.
APD ON - Press and hold down the Volume knob for 10 seconds, and wait for the Input LEDs to blink 5 times.

Advanced settings

Last updated: February 8, 2021 01:05. Revision #1041
dacmagic 200m / advanced settings
Important note: Make sure that the DacMagic 200M is in the Standby state, before changing any settings.
Factory reset: All user-stored settings (input, volume and output mode) will be erased and replaced by the unit's default settings.