ELRO AG40KE11B Manual

LOW BATTERY INDICATOR

The "LOW BATTERY" indicator on the front of the keypad will not flash un l the keypad emits an RF radio
signal. In short, the "LOW BATTERY" indica on won't be seen when the keypad is not used. When the indicator
does flash, it is strongly recommended that you replace the ba ery as soon as possible.

RESETTING THE KEYPAD

If you forget the master access code or for any other reason wish to
reset the device, you can reset the PIN to the factory default (1234)
by following these steps:
1. Remove the ba ery.
2. Press and hold any key for more than 1 second.
3. In the ba ery compartment, set the jumper as shown in the
image (e) by moving the cap.
4. Refit the ba ery and test it by pressing the default PIN (1234)
5. If the test is okay, set the jumper back to the old posi on as
shown in the image (f).

IMPORTANT WARNING:

This package can contain small parts and or material which can be dangerous for small children! Be aware of
this, and keep this away from small children!

SPECIFICATIONS

Ba ery : 9V/PP3 Alkaline x 1
Frequency : 868 MHz
Communica on Range : Min. 100m in open space
IP Ra ng : IP44
Dimensions : 115 x 86 x 40 mm
For more informa on about the ELRO HOME ALARM SYSTEM AG4000 visit www.elro.eu
Symbols:
Recycling and disposal: The WEEE symbol (a) means that this product and ba eries must be disposed
separately from other household waste. When it reaches its end of life, take it to a designated waste collec on
point in your area to guarantee a safe disposal or recycling. Protect the environment, human health and natural
resources! Read the manual (b) before use and store it in a safe place for future use and maintenance.
ELRO Europe | www.elro.eu ü
Postbus 9607 - Box E800
GUARANTEE
1006 GC Amsterdam - The Netherlands
Visit www.elro.eu
(e) (f)
1 J2 1 J2
(a) (b)
-3-
REMOTE KEYPAD
V2 Home is not a place, it's a feeling
MANUAL EN
AG40KE11B