Sierra Woodstoves S2300 Installation And Operating Instructions Manual

Advertisement

Quick Links

Please read this entire manual before installation. Save these instructions.
SAFETY NOTICE
CAUTION: HOT WHILE IN OPERATION. KEEP
CHILDREN, CLOTHING AND FURNITURE AWAY.
CONTACT MAY CAUSE SKIN BURNS.
IF THIS HEATER IS NOT PROPERLY INSTALLED,
A HOUSE FIRE MAY RESULT.
CONTACT LOCAL BUILDING OFFICIALS ABOUT
RESTRICTIONS AND INSTALLATION INSPECTION
REQUIREMENTS IN YOUR AREA.
FAILURE TO COMPLY WITH OWNERS' MANUAL
INSTRUCTIONS WILL VOID YOUR WARRANTY!
WARNING:
FOR
INSTALLATIONS
HOMES, DO NOT INSTALL IN SLEEPING ROOM.
This wood heater needs periodic inspection and
repair for proper operation. It is against federal
regulations to operate this wood heater in a manner
inconsistent with operating instructions in this
manual.
California Prop 65 Warning: This product can expose you
to chemicals including glass wool fiber and carbon
monoxide which the State of California has determined
can cause cancer, birth defects, and other reproductive
h a r m .
F o r
m o r e
www.P65Warnings.ca.gov
S2300 Wood Heater Manual
Installation and Operating
Instructions
IN
MOBILE
i n f o r m a t i o n
g o
PLEASE LEAVE THIS MANUAL WITH THE OWNER !!
GENERAL INFORMATION
Congratulations on your purchase of the Sierra Stove. We
are confident that your new stove will provide you with years
of safe, comfortable and efficient heating.
Your Sierra Stove is a free-standing/mobile home approved
wood fueled heating appliance tested to the ICBO TL-130 &
Canadian test ULC S627. Safety testing is according to UL'
1482 and UM 84. HUD standards.
This manual describes the installation and operation of the
Sierra S2300 wood heaters.
EMISSION CERTIFICATION STATUS
The S2300 model meets the U.S. Environmental Protection
Agency's emission limits New Source 2020,, ASTM
E3053-2017 and EPA Alternate Test Method (ATM) 125 for
cordwood. Under specific test conditions this heater has been
shown to deliver heat at rates ranging from 11,000 to 45,500
Btu/hr capable of heating approximately 2,100-2,600 square
feet. Actual heat output and space heated is determined by:
climate, home construction, species and moisture content of
wood.
This wood heater has a manufacturer-set minimum low
burn rate that must not be altered. It is against federal
regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating
instructions in this manual
Please read this entire manual before you install and use
your new room heater. Failure to follow instructions may
result in property damage, bodily injury, or even death.
Save these instructions for future reference.
SAFETY NOTICE
If this appliance is not properly installed, a house fire may
result. For your safety, follow the installation instructions.
Check with local building or fire officials about restrictions
and installation inspection requirements in your area.
Installation into mobile homes require outside combustion
air and special hearth attachments. For Mobile Homes, a
Combustion Air Kit P/N 11069 is available from your
dealer.
It is best to have a professional install your Sierra Stove. If
you prefer to install it yourself (see Installation
Instructions), be sure to obtain the proper permits. Have
the local building officials inspect the stove and chimney
pipe for safety and code compliance after the installation is
complete.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE
SERVING ANOTHER APPLIANCE.
t o
OVERALL DIMENSIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S2300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sierra Woodstoves S2300

  • Page 1 This manual describes the installation and operation of the Sierra S2300 wood heaters. EMISSION CERTIFICATION STATUS The S2300 model meets the U.S. Environmental Protection Agency's emission limits New Source 2020,, ASTM E3053-2017 and EPA Alternate Test Method (ATM) 125 for cordwood.
  • Page 2: Hearth Protection

    Step (b): Calculate R of proposed system. 4" brick of C-1.25, therefore Rbrick=1/C -1/1.25 -.80 1/8" mineral board of k-.29, therefore Rmin.bd.- 1/.29x.125-.431 S2300 Leg Base Dimensions Total R-Rbrick-Rmineral board-.8+.431=1.231 Step (c): Compare proposed system R of 1.231 to ACHIEVING PROPER DRAFT specified R of .893.
  • Page 3: Break-In Period

    500 F to 700 F for at least 45 minutes. The point MOBILE HOMES being, cure slowly without a hot fire. S2300 FREESTANDING HEATER * Curing can usually be observed by the effect of the paint Correct installation of the Sierra Stove employing outside turning flat as the heat radiates out from the hotter parts of the stove.
  • Page 4: Chimney Installation

    STEP BY STEP INSTALLATION CAUTION: Combustion air must be taken from outside of the mobile home and must not be obstructed by any brush, We suggest that you purchase a chimney kit from your snow or any form of debris. local dealer designed for mobile home installations.
  • Page 5 CAUTION 1. Use only an approved chimney system. 2. Do not intermix pipe systems. 3. No single-wall stove pipe may be used. ATTENTION: Be sure to secure the cover plate with grounding lug on the back of the pedestal so that the room air intake aperture is covered (Figure 3).
  • Page 6 Building Your Fuel Load Cordwood stoves require three loadings for proper operation. This includes kindling, starting load, and large load for long burn. For best performance the kindling load will provide heat for starting flue draft. Starting load provides firebox heat and coal bed for the large long burn load.
  • Page 7: Overnight Burning

    By using this control you will not only learn to regulate the S2300 STARTING INSTRUCTIONS temperature levels in your home but also be able to keep your glass door cleaner. Less air means slower fires and 1.
  • Page 8: Maintenance

    Gold or Nickel Doors: Plated doors require minimum cleaning. Should cleaning be required use a mild cleaner Fuel Sizes: S2300 takes 17" to 18" wood side to side. The on a soft cloth. We do not recommend the use of any type ideal fuel load is about 15 lbs.
  • Page 9 Should you have a warranty claim on your Sierra Wood Stove, notify your nearest dealer, or contact Sierra Products, Inc. at www.sierraproductsinc.net/customer-support/technical-service/ Sierra Products, Inc. 63 Laxalt Dr. Carson City, NV 89706 775-241-2586 P/N 140969-D S2300 WOOD STOVE MANUAL...

Table of Contents