Replacement Of Baffle; Fitting A New Door Glass; Fitting A New Door Seal - Masport Westcott 1000 Operating Instructions Manual

2. REPLACEMENT OF BAFFLE

Remove the slotted log guard by raising it up, rotate on an
angle into the firebox and remove through the door opening.
Remove the side bricks as described in "1. Replacement of
Firebricks". Once removed, the baffle retainer with vermiculite
insert can be removed through the door opening.
Repeat steps above in reverse to install a new baffle retainer
and/or vermiculite insert.

3. FITTING A NEW DOOR GLASS

Lift the door off the heater lay face down on a work-bench.
Loosen and remove the small stainless steel retainers that
hold the glass in place.
Remove the cracked glass panel, swapping it with the new
replacement glass panel.
Locate and screw down the glass retainers. Do not over
tighten the retainers.
Refit the door to the heater.

4. FITTING A NEW DOOR SEAL

This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
Pull out the old door seal. With a wire brush or the flat end of
a screwdriver, clean out the groove in the cast door that the
door seal beds into.
Run a bean of silicon in the groove of the cast door and press
the door seal into the groove.
Refit the door to the heater and close the door fully with
handle latched to help bed the door seal into the door.
Version 1.2 7