Download Print this page
Berkey PF-2 Manual

Berkey PF-2 Manual

Fluoride and arsenic reduction elements
Hide thumbs Also See for PF-2:

Advertisement

Quick Links

Berkey PF-2™ reduction elements are designed for use in conjunction with Black Berkey™
water purification elements to adsorb the following unwanted elements found in drinking
water.
 Fluoride
 Arsenic V and pre oxidized Arsenic III
 Other residual heavy metal ions
TECHNICAL INFORMATION:
FLUORIDE: Testing for fluoride was based on 20-30ppm of the ion in the influent aqueous
solution at a flow rate of no more than 3 gpm per cubic foot of media. Results of < 1ppm of the
fluoride ion in the effluent were typical for the media (>95% reduction). Under optimum conditions,
effluent concentrations of less than 50 ppb were readily achieved (>99.75% reduction).
ARSENIC: This product uniquely targets the entire family of arsenic oxide anions as well as the
arsenic cations.
REPLACEMENT:
Under normal conditions it is recommended that each set of two Berkey PF-2™ elements be
replaced after 1,000 gallons (The Berkey Light
PF-2™
filters should be replaced after 363 refills. If the system is refilled about one time per day, the
Berkey PF-2™
elements should be replaced annually, if the system is refilled about twice per day,
Berkey PF-2™
the
elements should be replaced about every six months).
New Millennium Concepts, Ltd. warrants this product to be free from defects in materials and workmanship for a period of 6 months from date of
purchase. New Millennium Concepts, Ltd. will replace or repair any product that it deems is not properly functioning during the stated warranty period.
Relief under this warranty is limited to the replacement or repair of defective materials or workmanship only. New Millennium Concepts, Ltd. shall not be
held liable for incidental or consequential damage to personal property from, but not limited to, a defective unit, improper use, abuse, accident, or neglect,
etc. No warranty will apply to units which have been used for purposes not intended, which have been altered so as, in the manufacturers judgment, to
affect adversely its performance. This warranty is for the original retail purchaser only, and cannot be transferred. Repair or replacement of parts will be
made upon delivery to manufacturer's plant or authorized service dealer at customer's expense. The laws of the State of Texas, USA, will govern any
disputes regarding this warranty or claim made. This warranty which is given expressly in lieu of all warranties, expressed or implied, or merchantability
and fitness for a particular purpose, constitutes the only warranty made by New Millennium Concepts, Ltd.
*For maximum removal efficiency, maintain the water being treated between a PH level of 5 and 8. Actual capacity is dependent on the level of
contamination of arsenic, fluoride and other competing heavy metal ions. Unusually high levels of these contaminants may reduce the capacity and
efficiency of the elements.
PF2-Instructions – 11-14 - © Copyright - 2003-2016 - New Millennium Concepts, Ltd. All rights Reserved.
Berkey
PF-2™ Fluoride and
Arsenic Reduction Elements
GENERAL WARRANTY INFORMATION
®
system is about 2.75 gallons therefore the
Berkey

Advertisement

loading

Summary of Contents for Berkey PF-2

  • Page 1 ARSENIC: This product uniquely targets the entire family of arsenic oxide anions as well as the arsenic cations. REPLACEMENT: Under normal conditions it is recommended that each set of two Berkey PF-2™ elements be Berkey replaced after 1,000 gallons (The Berkey Light ®...
  • Page 2 With clean hands, remove both blue caps from each end of each Berkey PF-2™ filter element. Place the rubber-priming button (tan colored) onto one end of a Berkey PF-2™ element and align the hole in the button with the hole in the Berkey PF-2™ element.