Panasonic SC-HTB690EB Service Manual page 37

Module type. (Example:BTM8630)
10.1.2. How to write the Blue tooth MAC
address to NFC module
1. Tap the "TCL BT TAG Writer" icon (
2. Select the BT module type (BTM8630 only) and tap it.
3. After selecting the module type, QR code scan screen is
3. After selecting the module type, QR code Scan screen is
displayed. Tap [Skip the scan.] to skip this screen . displayed. Tap [Skip the scan.] to skip this screen.
3. After selecting the module type, QR code Scan screen is
displayed. Tap [Skip the scan.] to skip this screen.
4. MAC Address and Device Name inputting screen appears.
Please input 12 digits numbers in MAC ADDRESS column
(* the 12 digits numbers are gained at Doct Mode and the ":"
will appear automatically when you input.)
DEVICE NAME will appear automatically, but you also
can delete it and input "SC-HTB690". (Once you do it after
Tag writer software has been installed, the default device
name always displayed as "SC-HTB690".)
) to execute.
5. Tap [Write to Tag]. then move the NFC part of your Android
5. Tap [Write to Tag], then move the NFC part of the Android
device close to the NFC antenna part of NFC P.C.B. unit
and hold it until a beep sound is heard.which means the
6. Wait till [Tag written successfully!] is displayed, tag writing
Android device is recognized by the NFC module.
6. When [Tag written successfully!] appears, Tap [Exit].
*Get the Bluetooth Mac Address at Doct Mode:
Enter Doct Mode:
47
1. While pressing and holding [Vol-] for 3 seconds on Main
unit, then press [Vol+] using the remote control, then
release all the presses. "T≡" appears on the Front Panel.
47
2. Press [
on the front panel, and then the Bluetooth Mac Address
appears.
For example:
37
Writer" software installation.)
5. Tap [Write to Tag], then move the NFC part of the Androi
device close to NFC antenna part of the NFC P.C.B. Unit.
device close to NFC antenna part of the NFC P.C.B. Un
6. Wait till [Tag written successfully!] is displayed, tag writin
is completed. Tap [Exit] to exit the "TCL BT TAG Writer"
is completed. Tap [Exit] to exit the "TCL BT TAG Write
software.
software.
]on the remote control, "BLUETOOTH" appears