Advertisement
Available languages
Available languages
433 Mhz
Rolling-Code
2-Channel
Factory settings code for Channel 1 = 11
Factory settings code for Channel 2 = 22
Programming instructions
1. Press the programming button on the opener/operator
2. On the code keypad, press "11" then the " < " button
3. The keypad is now programmed to the opener/operator
4. To open and close your gate/garage door opener, simply enter in the code "11" and press the " < "
button.
Changing the PIN code
1. Press and hold the "0" button followed bythe"<"button.
2. Release first the "<" button, then the "0".
3. Enter in the factory setting code "11" and press the "<" button.
4. Enter in your new desired code (up to 8 numbers) and press the "<" button when finished.
5. Enter your new code in again and press the "<" button again.
6. Your new code is now entered into the code keypad
7. Make sure to make note of your PIN code
Programming Channel 2 is the same as above, rather, change "11" to "22" and "<" to ">".
Wireless Code Keypad SKP
Advertisement
