Hitachi MXS2ESLL1 Probe Instruction Manual page 16

MN1-6403 Rev. 1
Caution
Constantly check for anything abnormal about the patient's condition and the equipment.
Continued use without noticing that an abnormal condition has occurred can result in an electric
shock and injury to the operator or patient. If an abnormal condition occurs, immediately move the
equipment away from the patient and stop use of the probe.
The equipment is vulnerable to damage by impact. Therefore, handle it with care.
There is a risk of damage to the equipment when the equipment is fallen or hit somewhere.
Do not use this probe with other equipment except for those specifically approved in the manual.
Use with unapproved equipment can result in an electric shock, burn, or other injury to the patient
or operator and damage to the probe and the other equipment.
Scan for minimum time necessary at the lowest possible acoustic output.
Acoustic output may affect the patient's internal tissues.
For details about the acoustic output, please refer to the documentation supplied with the ultrasound
diagnostic instrument.
Regularly perform maintenance inspection and safety tests of the equipment.
If you use equipment for a long period of time, it can reduce the performance, or cause smoke or fire. If
anything unusual occurs, immediately stop using it and contact one of our offices and/or distributor's offices
listed on the back cover.
Use, move and transport the equipment under the environmental conditions specified in this manual.
Otherwise, it may be damaged.
Do not use with a defibrillator.
This should result in the probe damaged. If you have to use a defibrillator with the probe in place, make sure
to conduct a safety tests according to instruction manual MN1-6105.
Keep the angle knob in the free position during an operation of curving.
Operating the probe while locked, it may become unusable.
Do not bend or pull the insertion portion unnecessarily.
This could make the probe unusable.
Do not touch the connector terminal pin of the probe.
Electrostatic discharge may result in malfunction of the probe.
Do not touch the probe connector of the ultrasound diagnostic instrument and the patient at the same time. It
can cause electric shock to the patient.
Please hang the ring to the stand for drip infusion.
If the probe is hung in the unstable point , it may the cause to drop and break down.
After hang the probe , do not draw out Probe and do not add weight .
It may the cause to drop and break down.
When hang or remove the probe ,be careful not to drop the Probe .
It may the cause to drop and break down.
DM# 126288 V1
-12-