Breville the Smart Kettle Luxe Instruction Book page 10

BEFORE FIRST USE
Remove and safely discard any packaging
material or promotional labels attached to your
kettle. It is recommended before first use to
fill the kettle to the maximum level with cold
tap water, bring to the boil by selecting the
BOIL 212° button. Allow the water to boil, then
discard the water.
Your kettle will only operate when positioned
on the power base. The kettle will automatically
switch off when the water has reached the
selected temperature.
OPERATION OF YOUR KETTLE
1. To fill the kettle, remove it from the power
base and open lid by pressing the lid
release button. Fill with the desired amount
of water.
NOTE
Always fill the kettle between the minimum
and maximum marks on the water window. Too
little water will result in the kettle switching
off due to the safety boil dry protection. Filling
above the maximum mark (MAX) may result
in boiling water splashing from the kettle.
2. Ensure the lid is closed and locked firmly
into place. Position the kettle securely onto
the power base. Insert the power plug into
a 110 /120V power outlet. The START/
CANCEL and 212° BOIL button surrounds
will illuminate in white for one minute.
A beep will sound for two seconds.
The START/CANCEL button surround will
automatically switch off after one minute if
not selected.
NOTE
If the START/CANCEL button is pressed
(before selecting a temperature button),
the START /CANCEL button surround will
illuminate in red and the 100° button surround
will illuminate and the kettle will start heating.
10
3. Select the desired setting by pressing one
of the five temperature buttons (175°, 195°,
200°, 205°, 212°). The selected button and
the START/CANCEL button surround will
illuminate in white.
NOTE
The KEEP WARM function can be
selected before, during or on completion of the
water heating cycle.
4. Press the START/CANCEL button and
the surround will illuminate in red, the
selected temperature button surround
will illuminate and the kettle will start
heating. Do not remove the kettle from
the power base during operation. Ensure
the kettle has switched off after the water
has boiled or the selected temperature
has been reached before removing the
kettle from the power base. If the kettle
is removed from the power base during
the KEEP WARM function the kettle will
automatically switch off.
5. When the kettle has heated the water to
the selected temperature, 3 beeps will
sound, the START/CANCEL button
surround illumination will switch off,
and the selected temperature button
surround will remain illuminated for
1 minute before switching off.
6. If the KEEP WARM function has been
selected, the KEEP WARM button
surround will remain illuminated in red,
the selected temperature button surround
will remain illuminated in white, and the
kettle will maintain the desired setting for
20 minutes.
7. If further heating of the kettle is not
required, unplug the power cord and empty
the water from the kettle. Replace the kettle
onto the power base and close the lid.