Lights Alive FireFly FF-351 Instructions And Specifications

QUICK START

If you're one of those folks that just wants to start using your new FF-351 now and read the
instructions later, it's quite easy to be up and running, literally in seconds. Three easy steps are
all that are necessary for professional lightning simulation.
1) Connect lights (up to 1500 watts per channel) to the left and right channel sockets on the
rear of your FF-351.
2) Connect your amplifier or amplified speakers to the 1/8" stereo AUDIO OUTPUT jack on
the rear of the lightning simulator.
3) Connect AC power.
No other connections or adjustments are required for basic operation.
WHEN POWERING UP...
Upon power up, the FF-351 goes through a quick self-test and the Lights Alive logo appears.
After about three seconds, the test is complete and the system is fully functional. If the audio
source was in the loop mode at power down, the 351 will begin operation automatically. If it was
in the triggered mode, it is now awaiting a trigger to begin operation.

CUSTOMIZED SETTINGS

Five pushbuttons allow you to fully customize your FF-351 settings. Pressing the center MENU
button gives you access to seventeen (17) additional windows. Pressing the UP and DOWN
buttons scrolls through the windows. The (+) and (–) buttons alters the setting for that particular
window. Pressing MENU again will exit the program mode and save your changes. The windows
in order are:
POWER OFF
A soft power off happens immediately at the press of the (+) button. The unit will be back
up and running after touching any button.
LEVEL-LEFT
Adjusts the audio level (sensitivity) of the left channel.
LEVEL-RIGHT
Adjusts the audio level (sensitivity) of the left channel.
DEPTH-DIMMER
Determines the amount (depth) of the dimming effect.
LEVEL-STROBE
Sets the level (sensitivity) of the strobe control channel.
FireFly FF-351
Instructions and Specifications