Profi Care PC-TVL 3068 Instruction Manual page 30

3. Place the base plate on the housing. The base plate can
only be mounted in one position. Please use the guide
pin to fix it in place.
NOTE:
On the underside of the base plate you will see letters
(A, B, C). The hole with the letter "A" must be on the
front of the appliance.
4. Tighten the base plate with the three screws.
5. Thread the cable into the recess provided on the base
plate.
6. Now turn the fan over and place it on a suitable solid
surface.
Remote Control
• Remove the remote control from the compartment on the
back of the appliance.
• The cordless remote control has a range of up to 10 me-
ters. When using the remote control, please ensure that
there are no obstacles placed between it and the sensor
on the appliance.
Inserting of the Battery
NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the battery compartment on the bottom of the
remote control by holding the lever inwards and pulling
out the battery compartment.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity.
3. Then close the battery lid.
Putting into Service
Electrical Connection
1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the appli-
ance. You can find this information on the nameplate.
2. Connect the appliance to a duly installed protective
contact socket.
Use
NOTE:
• The buttons are to be found both on the appliance
itself and on the remote control.
30
PC-TVL3068_IM
NOTE:
• The buttons on the appliance are touch keys. Gently
touch the buttons with a finger to execute the function.
Whenever a button is pressed, it will be confirmed by
a beep sound.
• For the meaning of the symbols please see the
following table.
• The appliance has a memory function: the last param-
eters set are stored. When it is switched on again, the
fan starts up with the last settings.
Button and Symbol Explanation
Display
Button Function
Indications
Standby
Start or stop the fan
TIMER Timer operation: 1 to 8 hours
NATURAL Wind-mode: Natural mode, sleep
SLEEP mode, or normal mode
SPEED Speed setting: slow / medium / fast
Start or stop oscillation
Switching the Fan On and Off
Press the button to switch the appliance on or off.
Speed
Press the button repeatedly to select one of three
speeds:
• 1 slow
• 2 medium
• 3 fast
Wind Change Functions
The appliance has the two special functions:
NATURAL and SLEEP. The speed of the fan buries be-
tween the functions.
Press the button to switch these functions on.
• Press 1 × = NATURAL
This mode simulates natural wind movement. Pressing
the button you can change the speed level.
• Press 2 × = SLEEP
Relax in this mode with rich wind variants. Pressing the
button you can change the speed level.
• Press 3 × = Normal Mode
Choose the speed level by pressing the button.
13.08.19