Operation - Milwaukee REDLITHIUM L4 HBL BLACK Operator's Manual

OPERATION

Unzip the pocket and pull out the power cable. Plug
the power cable into the port on the end of the char-
ger/controller. Tuck the charger/controller into the
pocket and zip closed.
To turn on, press and hold (1 to 2 seconds) the
power button. The button will be turned to High and
the red LED will light.
Temperature setting can be adjusted at any time
by pressing the power button. Each press will cycle
through the temperature settings.
To the heated gear, press and hold (1 to 2
nections and charge the battery pack.
HEATED GEAR CARE
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
battery pack and charger/controller from the
heated gear before performing any maintenance.
Never disassemble the heated gear, battery pack
or charger. Contact a MILWAUKEE® service
facility for ALL repairs.
If the heated gear does not start or operate properly
with a fully charged battery pack, clean the contacts
on the battery pack. If the heated gear still does not
work properly, return the heated gear, charger and
battery pack, to a MILWAUKEE® service facility
repairs.
To reduce the risk of personal in-
WARNING
jury and damage, disconnect and
remove battery pack and charger/controller from
pocket before washing. Never immerse your
charger/controller, battery pack, or charger in
To clean the heated gear:
1. Remove battery pack and battery holder.
2. Push the power cord completely into the battery
holder pocket and fasten closed.
3. Machine wash, Gentle Cycle in warm water. Do not
use bleach. Do not dry clean. Do not wring or twist.
4. Tumble Dry on Low Heat. Do not iron.
-
5