Advertisement
SYMBOLOGY
Volts
Direct Current
Machine wash, gentle cycle in warm water
Do not bleach
Do not wring or twist
Tumble dry, low heat
Do not iron
Do not dry-clean
Regulatory Compliance Mark (RCM).
This product meets applicable regulatory
requirements.
Read Operator's Manual
This charger was only suitable for indoor
use. Never expose the charger to rain.
Class III appliance
T3.0A
Time-lag fuse 3.0A
FUNCTIONAL DESCRIPTION
2
3
5
4
1. Jacket
and Pocket
High: Red LED
Medium: White LED
Low: Blue LED
2. Power Cable
3. Battery Controller Pocket
4. USB out
5. Fuel Gauge LEDs
6. USB power button
1
8
9
6
7
10
Power Buttons
7. Micro USB in
8.Charging LEDs
RED: Charging
Green: Charging
complete
9. DC out
10. Battery port
ASSEMBLY
Recharge only with the charger
WARNING
manual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body of
the battery controller. Make sure it latches securely
into place.
Insert the power cable (from inside the battery
controller pocket) into the power cable port on the
battery controller.
Place the battery controller into the pocket and zip
closed. Use the smaller rear section of the pocket
to hold smaller M12™ batteries and if necessary
the front section of the pocket which can accommo-
date larger battery packs.
To remove the battery, push in the release buttons
and pull the battery pack away out of controller.
Using the USB Out Port
The USB port can be used to charge a cell phone,
MP3 player, or other personal device that uses less
than 5V, 2.1A of DC electrical current. The cord can
be run from the battery controller pocket, through the
grommet and channel on the interior of the jacket,
and through another grommet into a side pocket. It
is not recommend to use the pocket warmer when
an electronic device is charging in a pocket.
To turn on the USB Out Port, press the USB power
button. The USB Out Port will remain on for two
hours before turning off automatically.
Fuel Gauge
Press the USB power button to display the battery
pack's remaining power on the fuel gauge LEDs.
OPERATION
The zone power buttons are located on the upper left
side of the jacket. Use the jacket
power buttons to control the two zones.
To turn on, press and hold (1 to 2 seconds) the
desired zone's power button. The desired zone will
turn on to High and the red LED will illuminate.
Temperature setting can be adjusted at any time by
pressing the specific zone's power button. Each
press will cycle through the selected zone's
temperature settings. To turn off the heated jacket,
press and hold (1 to 2 seconds) each of the zone's
power buttons. The LED(s) will turn off. If the
heated jacket turns off unexpectedly, check
connections and charge the battery pack.
To reduce the risk of injury, always
WARNING
If the heated jacket does not start or operate properly
with a fully charged battery pack, clean the contacts
on the battery pack. If the heated jacket still does
not work properly, return the heated jacket, charger
and battery pack, to a
for repairs.
3
and pocket
CARE
service facility
-
-
Advertisement
