Advertisement
Quick Links
QUICK USER GUIDE
3 SAVABLE
HEIGHTS
RAISED
RIDE HEIGHT
LOWERED
PROGRAM
ALL DOWN
(HOLD 5 SEC)
i
Saving Heights (Must Be Calibrated)
To save a new height, manually adjust the vehicle to the desired
position. Once confirmed, hold the position 1, 2 or 3 button down for
3 seconds until that position indicator flashes and then becomes
solid
FRONT
CONTROLS
PAIRED
CONTROLS
COMPRESSOR
STATUS
INDICATOR
REAR
CONTROLS
INDIVIDUAL
CONTROLS
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for AccuAir e-Level+
Summary of Contents for AccuAir e-Level+
- Page 1 QUICK USER GUIDE 3 SAVABLE HEIGHTS RAISED FRONT CONTROLS RIDE HEIGHT PAIRED CONTROLS COMPRESSOR STATUS LOWERED INDICATOR PROGRAM REAR CONTROLS INDIVIDUAL ALL DOWN CONTROLS (HOLD 5 SEC) Saving Heights (Must Be Calibrated) To save a new height, manually adjust the vehicle to the desired position.
- Page 2 Settings To change your system settings from the TouchPad, momentarily press the program button and then make adjustments with the below reference RIDEMONITOR™ MODE ACCURACY LEVEL SETTING Backlighting Increase Accuracy #3 Most Accurate Ride-Height & Most Adjustments On-Start RideMonitor™ Accuracy #2 Mode Factory Backlighting...
- Page 3 Calibration If you are using height sensors, then you will need to calibrate the e-Level+ system before use. This process should be completed anytime suspension parts are changed or replaced CALIBRATION WILL AUTOMATICALLY RAISE AND LOWER THE VEHICLE. BE CAREFUL THAT THE VEHICLE IS PARKED ON LEVEL GROUND AND IS CLEAR OF OBSTRUCTIONS Automatic Calibration Hold the “Program Button”...
- Page 4 Error Codes Use the following error codes to identify what is not functioning correctly. Provide this information to your installer or to AccuAir Tech Support: (805) 481-6500 Flashing Trouble Codes All 3 Position Buttons flash simultaneously to indicate an error...
Need help?
Do you have a question about the e-Level+ and is the answer not in the manual?
Questions and answers