Tunstall ePat lite Manual

TV
The green LED in the TV icon [6] is illuminated
during TV operation*.
Switching TV on
 Tap the TV icon [6].
 TV is switched on. The green LED in the TV icon [6] is
illuminated. Entertainment is off.
Selecting programme
 Select the programme by repeatedly tapping the arrows of
the programme selector [5].
Back
 When tapping, the LED next to the tapped arrow lights up
briefly.
Adjusting the volume
 Adjust the volume by repeatedly tapping the volume
control icons [7] "–" or "+".
Down
 The sound is transmitted via the loudspeaker [2].
Alternatively a standard headphone (3.5 mm jack plug) can
be connected to the jack [10].
Switching TV off
 Tap the TV icon [6] or directly switch to entertainment
by tapping the entertainment/blinds icon [4].
* NOTE! All functions of the ePat®
lite
these instructions for use. However, depending on the
installation in your hospital, only a selection of these
functions may be available. Your nursing staff will tell
you which functions are available to you.
Switching entertainment on
 Briefly tap the entertainment/blinds icon [4].
 The green LED in the entertainment/blinds icon [4] is
illuminated. Entertainment is switched on. TV is off.
NOTE! If the green LED in the entertaiment/blinds icon flashes
instead of illuminating, you have pressed too long and thus
switched on blinds control mode instead of entertaiment.
Please try again.
Selecting programme
Forward
 The number of LEDs lit on the program selector [5] indicates
the current entertainment programme.
 Select the programme by repeatedly tapping the arrows of
the programme selector [5]:
Back
Adjusting the volume
Up
 Adjust the volume by repeatedly tapping the volume
control icons [7] "–" or "+".
Down
 The sound is transmitted via the loudspeaker [2].
Alternatively a standard headphone (3.5 mm jack plug) can
be connected to the jack [10].
Switching entertainment off
 Briefly tap the entertainment/blinds icon [4] or directly
switch to TV by tapping the TV icon [6].
are described in
Entertainment
The green LED in the entertainment/blinds icon [4]
is illuminated during entertainment operation*.
Forward
Up
Blinds control
The green LED in the entertainment/blinds
icon [4] is flashing during blinds control mode*.
Switching blinds control mode on
To lower or raise the blinds, you must first switch on blinds
control mode:
 Hold down the radio/blinds icon for approx. three seconds
and then release it.
 The green LED in the entertainment/blinds icon [4] is
illuminated. Blinds control mode is switched on.
NOTE! If the green LED in the entertainment/blinds icon
is illuminated instead of flashing, you have pressed too
briefly and switched on entertainment instead of blinds
control mode. Please try again.
Lowering and raising the blinds
During blinds control mode you can lower and raise the
blinds:
 Lower or raise the blinds by repeatedly tapping the
arrows of the programme selector [5]:
Lower
the blinds
 When tapping, the LED next to the tapped arrow lights
up briefly.
If you do not press the program selector [5] for more than
five seconds, blinds control mode is automatically
switched off. The green LED in the entertainment/blinds
icon [4] is no longer flashing.
Bracket
 Insert the ePat® into the bracket from
lite
above.
Bracket
Raise
the blinds