Installation; Cleaning And Care - Parkside 40W PSCD 1 A1 Operation And Safety Notes

Installation

Note: Remove all packaging materials from the
product.
Attach the spotlight
included locking screw
spring washer .
7 a
Place the spotlight
stand .
4
Check the stability of the spotlight
Align the spot into the desired direction. You may
need to slacken the screw of the hinge joint
and locking screw
the screw of the hinge joint
screw again, to ensure a secure hold of the
6
spotlight .
2
Use
Insert the mains plug
Note: Insert the mains plug
sponding IPX4 socket only during outdoor use.
Or the mains plug
if no corresponding IPX4 socket can be found.
Switch on the product by turning the rotary
switch .
8
Turn the rotary switch
brightness level of the spot
Turn the rotary switch
color continuously from warm white to cold white.
Note: The accessible surface, especially heat
sink, become very hot when operating, to prevent
burn, use the handle
desired position.
USB socket
You can find the USB socket
of the product, it was protected by a protective
cap . You can charge mobile phones, tablets
9
and other such devices with this USB socket
Open the protective cap
Insert the USB plug of the USB cable (not included)
into the USB socket
Insert the USB plug at another side of the USB
cable into the small electronic devices you wish
to charge.
to the stand using the
2 4
, washer and
6 7 b
on a stable substrate with
2
.
2
. After alignment, tighten
6
and locking
3
in the mains socket.
5
to the corre-
5
should be for indoor use
5
further to adjust the
8
.
2
to change the light
11
to move the product to
1
on the back
10
.
9
.
10
Switch on the product by turning the rotary
switch .
8
Remove the USB cable as soon as charging is
complete.
Close the protective cap
Note: The USB socket
from water when the protective cap
pletely closed. Water may enter the product if
the protective cap

Cleaning and care

3
Never immerse the product in water or other
liquids. Otherwise the product can be damaged.
R emove the mains plug
and allow the product to cool down.
Clean the product with a lint-free, slightly moist
cloth and mild cleaning agent.
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
. authority for more details of how to
10
dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
.
9
can only protected
10
is com-
9
is not corrected posited.
9
from the mains socket
5
GB/IE 11