Scope Of Delivery; General Safety Instructions - Parkside 40W PSCD 1 A1 Operation And Safety Notes

Scope of delivery

Check immediately after unpacking that the parts are
complete and that the product is in proper condition.
1 LED spotlight
1 Instructions for use
General safety
instructions
BEFORE USING THE PRODUCT, PLEASE FAMIL-
IARISE YOURSELF WITH ALL OF THE SAFETY
INFORMATION AND INSTRUCTIONS FOR USE!
WHEN PASSING THIS PRODUCT ON TO OTHERS,
PLEASE ALSO INCLUDE ALL THE DOCUMENTS!
DANGER TO LIFE AND ACCI-
DENT HAZARD FOR TODDLERS
AND SMALL CHILDREN! Never
leave children unattended with the packaging
material. The packaging material represents a
danger of suffocation. Children frequently under-
estimate the dangers. Please keep the product
out of the reach of children at all times.
This product may be used by children age 8 years
and up, as well as by persons with reduced
physical, sensory or mental capacities, or lack-
ing experience and / or knowledge, so long as
they are supervised or instructed in the safe use
of the product and understand the associated
risks. Children should not be allowed to play with
the product. Cleaning and user maintenance
should not be performed by children without
supervision.
DANGER OF SUFFOCATION! Children could
swallow and choke on small included parts (e.g.
screws). Keep children away from the work area
during assembly.
The LED cannot be replaced. If the LED fails
at the end of its life, the entire product must
be replaced.
The mains cable of this product cannot be
replaced; if the mains cable is damaged, the
product shall be destroyed.
10 GB/IE
Danger to life
by electric shock
Always check the product for damage before
connecting it to the mains. Never use the product
if it shows any signs of damage.
Protect the mains cable against sharp edges,
mechanical stresses and hot surfaces.
Always unplug the mains plug from the mains
socket before installation, dismantling or cleaning.
Disconnect the product from the mains supply
if it is not going to be used for some time (e.g.
holiday).
Prior to installation, verify that the mains voltage
on site corresponds with the operating voltage
required for the product (230 V∼ 50 Hz). Other-
wise do not install the product.
CAUTION! DANGER OF BURN INJURIES!
To prevent burns, verify the product is switched
off and has cooled down for at least 15 min
before touching it. The product can become
very hot.
FIRE HAZARD! Fit the product so
that it is at least 1.0 m away from the
1 .0 m
material to be illuminated. Excessive
heat can result in a fire.
CAUTION! RISK OF INJURY!
Broken lamp glass must be replaced
before any further use is made of the
product.
The product is only suited for use with the built-in
LED control gear.
The product continues to draw a small amount
of power even if the product is off as long as
product is connected to supply mains. To switch
the product off completely, unplug the mains
plug from mains socket.
5
Never direct the LED light beam on to reflective
surfaces or at people or animals. Failure to ob-
serve this advice may result in eye injury and /
or loss of sight to people or animals. Even a weak
LED light beam can cause eye damage.
The product is not suitable be used as a hand
held luminaire. Do not handheld the product
when it is in operation.
Only mount the spotlight
stand . Do not directly mount the spotlight
4
on another surface, e.g. concrete wall or metal
frame, etc.
on the supplied
2
2