AMT PANGAEA ULTIMA U2 Firmware Installation

AMT PANGAEA ULTIMA U2 Pre/Post FX firmware
When you use this firmware the U2 is divided into two parts — the Pre section and the Post section.
Both sections have their Inputs, Output, and Effects.
The Pre section:
Input — IN L
Output — OUT R
Effects: Noise Gate (global setting)
Compressor
Phaser
Resonance Filter (wah-wah etc.)
In this chain you can use any preamp, it could be a one-channel as well as a multi-channel preamp.
Meaning the AMT products, you can choose from:
One-channel preamps: AMT LA-1 series;
Two-channels preamps: AMT LA-2 series;
Three-channels preamps: AMT SS series.
PreOut
OUT_R
Pre/Post FX
OUTPUT
PostOut OUT_L
ULTIMA U2
Pic. 1 — The common U2 Pre/Post chain with one preamp.
AMT Bricks series (these preamps have Bypass modes and they can be
chained in series);
The Post section:
Input — IN R
Output — OUT L
Effects: IR cabsim (1 IR for both L/R channels per preset)
Parametric Pre/Post EQ
Hi/Low pass filters + Presence
Delay or Reverb effect per preset
PostIn
IN_R
IN_L
PreIn
Preamp
OUTPUT
INPUT
Guitar