LG LSWS306ST Service Manual page 20

DISASSEMBLY INSTRUCTIONS
b. Remove the 3 convection element screws.
(The convection element is fragile. Care
should be taken to avoid any risk of injury)
c. Pull the element forward so that you can
access the terminals and disconnect the wires.
CAUTION
Be careful not to bend the fan blade.
3) To remove Blade fan(Convection fan)
a. Remove nut by screwing clockwise.
(be careful fan blade is bent easily)
b. Fan blade can be replaced from inside oven.
Fan Blade
Fan Cover
Nut
Fan Cover
Scews
(4ea)
Fan Motor
Convection
Heater
Mounting
Scews
(3ea)
Bushing
Cavity
Washer
Inner Outer
4) To remove the halogen lamp & socket assembly
a. There are three halogen lamp & socket
assembly in the oven cavity.
Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA
Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA
Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA
Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA Halogen lamp 3EA
b. Insert a flat blade
screwdriver into the
guide hole and pull off.
C. Replace the halogen
lamp, then reinstall the
glass cover.
* Note : The above instructions
can be used for
replacing any of the
halogen bulbs in either oven.
5) To remove oven temperature sensors,
Remove the 2 screws from the temperature
sensor bracket.
Pull the temperature sensor forward and
remove the connector.
3-5