Turning Technologies PresenterCard Quick Start Manual

PresenterCard
About PresenterCard
PresenterCard is a radio frequency hardware clicker that interacts with Turning Technologies, LLC polling software allowing
presenters mobility in the classroom. Additionally, presenters have the ability to customize the device to their needs.
System Requirements
The following requirements are necessary for PresenterCard to properly function:
One of the following receivers:
RRRF-03 receiver - 2.7 firmware or higher
l
RRRF-04 receiver - 2.7 firmware or higher
l
One of the following software applications:
TurningPoint - 6.0 or higher
l
TurningPoint AnyWhere PC and Mac - 3.0 or higher
l
Changing the PresenterCard Channel
The PresenterCard and RF receiver channels must coincide.
1
Press the on the PresenterCard.
2
Press or
3
Once the desired channel number is shown on the LCD display, press
PresenterCard Button Functions
The table below defines each programmable button on the PresenterCard.
Button TurningPoint
The Start/Stop button is used to
open/close polling.
The Back button is used to
move backwards through a slide
deck.
The Forward button is used to
advance through a slide deck.
to increase or decrease channel numbers.
TurningPoint AnyWhere
The Start/Stop button is
used to open/close polling.
The Back button is used to
move backwards through a
slide deck.
The Forward button is used
to advance through a slide
deck.
to set the channel.
PresenterCard Programming
N/A
The Back button is used to move in des-
cending order through channel numbers dur-
ing programming.
The Forward button is used to move in
ascending order through channel numbers
during programming.
1