Download Print this page
Living & Co JUNO WHITE Instructions

Living & Co JUNO WHITE Instructions

Table lamp

Advertisement

Quick Links

Please read these instructions and warnings carefully before operating to ensure safe
Warnings:
This is a Class II product and does not require an earth connection.
Always use the correct type and wattage of bulb.
When changing a bulb, always switch off the light at the wall socket and allow the bulb
to cool down before handling.
Dispose of old bulbs carefully.
Do not switch on the light until the installation is complete.
Do not cover the lamp or bulb during use as this could be a potential safety hazard.
Turn off the appliance when not in use.
The luminaire is not intended for use by children unless suitable adult supervision is
provided.
Children should be supervised to ensure they do not play with the luminaire.
The fitting is intended for indoor use only.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in order
to avoid a hazard.
To prevent damage to the mains cord, do not let it pass over sharp corners, edges or
hot surfaces.
• This lamp should only be used on a flat and stable surface.
• This lamp is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance, by a person responsible for
their safety.
• Never touch the bare bulb with your bare fingers or hands.
• Grease or oil from fingers can damage the bulb and cause the bulb to burn out, reduce
its operating life, or for halogen bulbs explode. It is recommended to use soft cloth or
facial tissue when handling the bulb.
CAUTION: Ensure that the light bulb is not within the recommended 0.5m of any surface
when operating as this could be a potential safety hazard.
CAUTION: Never exceed the bulb wattage stated.
MARKETED BY: The Warehouse, 26 The Warehouse Way, Northcote, Auckland 0627 - Phone: 0800 422274
Living & Co
JUNO TABLE LAMP WHITE
Instructions
and satisfactory operation of this product.
Please also retain these instructions for future use.

Advertisement

loading

Summary of Contents for Living & Co JUNO WHITE

  • Page 1 Living & Co JUNO TABLE LAMP WHITE Instructions Please read these instructions and warnings carefully before operating to ensure safe and satisfactory operation of this product. Please also retain these instructions for future use. Warnings: This is a Class II product and does not require an earth connection. •...
  • Page 2 Assembly: 1. Remove protective plastic overwrap from the lamp shade. 2. Remove the threaded plastic shade ring (retaining nut) from the lamp holder. 3. Install the lamp shade onto the lamp holder body. 4. Replace the threaded plastic shade ring (retaining nut) onto the lamp holder body 5.

This manual is also suitable for:

9401063532889