Advertisement
3. OPERATION
WARNING! Always use this tool with the cylinder head removed from the vehicle to avoid carbon entering the cylinder
bores which may damage the engine.
3.1
Remove the injector and sealing washer from the cylinder head.
3.2
Select the appropriate reamer and fit onto the centring pilot, align the hex screw with the flat on the pilot and tighten using
the 2.5mm hex key supplied.
3.3
Connect the T-Bar to the centring pilot and position the tool into the injection aperture.
3.4
Apply a small amount of lubricant to the injector seat and gently turn the reamer in a clockwise direction, until all the
carbon deposits have been removed. DO NOT apply too much pressure and apply more lubricant if required.
WARNING! Take care not to cut into the metal seat.
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to establish
s
the current procedure and data.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle
centre and disposed of in a manner which is compatible with the environment.
Sole uK Distributor
Sealey Group,
Bury St. Edmunds,
Suffolk.
Original Language Version
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
VS2055.V4 Issue: 1 - 28/11/13
Advertisement
