Advertisement
© 2016 Philips Lighting Holding B.V. All rights reserved.
When using electrical equipment, basic safety precautions should always be followed, including the following:
1. The ASW‐EBB uses a separate LED array for emergency mode. During emergency mode, only this LED will be
illuminated.
2. The ASW‐EBB must be connected to an unswitched AC power source, 120 or 277V as indicated.
3. When installing the ASW‐EBB, make sure all connections are in accordance with the National Electrical Code and any
local regulations.
4. To reduce the risk of electrical shock, disconnect the AC input and the inverter connector before servicing.
5. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
6. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
7. Servicing should be performed by qualified service personnel.
8. Do not use this equipment for other than intended use.
Philips Lighting North America
Philips Lighting Canada Ltd.
Corporation
281 Hillmount Road,
200 Franklin Square Drive,
Markham ON, Canada L6C 2S3
NJ 08873, Somerset
Sheet# 443561064920 revision D
A
ERO
IMPORTANT SAFEGUARDS FOR EBB OPTION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Revised 1/7/2015
S
LED
W
CAPE
S
ALL
CONCE
Page 6 of 6
Advertisement
