Advertisement
© 2016 Philips Lighting Holding B.V. All rights reserved.
2. Allow door to slide down on hinge, then swing to open.
See Figure 3a
3. Disconnect all of the wires connected to the LED driver.
4. To remove the driver door assembly, pinch the driver
door hinge together to unlock from hinge bracket. See
Figure 3b
5. Remove the four (4) screws holding the driver bracket
to release the driver, from the lens frame. See Figure
4a and Figure 4b
Sheet# 443561064920 revision D
Figure 3b
Figure 4a
A
S
LED
ERO
CAPE
DRIVER BRACKET
THERMAL INTERFACE
6. Remove the thermal interface material off of the old
7. Replace the old LED driver thermal interface material to
8. Place the LED driver and Bracket back onto the driver
9. Reconnect LED driver (See Figure 1) to the luminaire.
10. Replace the driver door assembly and re‐tighten the (4)
11. Reconnect the luminaire to power.
Revised 1/7/2015
W
S
ALL
DRIVER SCREW(S)
Figure 4b
driver, from the top and bottom.
new driver, from the top and bottom.
door and secure the bracket screws in place.
door retaining screws. Torque to 28‐36 in‐lb, see Fig 2.
CONCE
DRIVER
Page 5 of 6
Advertisement
