Table of Contents
Advertisement
Configuring the External
Device
Use this procedure to select the external device
that connects to the Enhanced T
1. From the primary Enhanced T
press Menu to configure the software for the
external system. The menu appears on the
LCD.
2. Use the Tracker Ball to scroll through the menu
until Config Devices appears on the LCD
screen. Press zoom or focus to select Config
Devices.
3. Press Next to scroll through the available
devices. Refer to the following chart to
determine which device to select.
Device Setting
Use with...
Device
16-camera Multiplexer and
Intellex
=Mux 16
= POSEM
Device
9-camera Multiplexer
=Mux 9
= POSEM
Device
4-camera Multiplexer, dual page
Quad Splitter, and Quad Splitter
=Mux 4
(RVQX7X)
= POSEM
Device
Quad Splitter with DB9F-RJ45
connection
=Quad
= POSEM
Device
Domes connected to dedicated
monitors (no external device).
=None
Device
For Service use only
=PC
4. When the correct configuration appears on the
LCD, press Menu.
Continue with Setting Primary and Secondary
Unit.
RCTT16BE VM16 PLUS ENHANCED TOUCH TRACKER
INSTALLATION GUIDE
T
.
OUCH
RACKER
T
,
OUCH
RACKER
13 of 15
Setting Primary and
Secondary Unit
NOTE: Quad Splitter, Intellex 1.x and 2.0, and
stand-alone installations support only one Touch
Tracker.
If you have two Enhanced T
installed, one must be designated as Primary; the
other must be designated as Secondary. If you
have only one Enhanced T
it must be designated as Primary.
1. Press Menu.
2. Using the Tracker Ball, scroll the menu choices
until Tog Primary/2nd appears on the LCD.
3. Press zoom or focus to select Tog
Primary/2nd. Zoom selects the top line; focus
selects the bottom line.
4. Press Next to toggle between setting the
Enhanced T
T
OUCH
RACKER
secondary. When the appropriate choice
appears on the LCD, press Menu. The
Enhanced T
T
OUCH
RACKER
Repeat this procedure for each Enhanced T
T
.
RACKER
T
OUCH
RACKERS
T
installed,
OUCH
RACKER
as primary or
will reset.
OUCH
8000-2672-01, REV. D1
Advertisement
Table of Contents
