User's Guide
APPENDIX D: REMOTE CONTROL PANEL USER'S GUIDE
System Diagram
Before using the remote control panel, you must confirm the RS-485 ID address of
each multiplexer and that all cables are properly connected.
After you connect the RS-485 cable, the remote control panel will automatically search
for any multiplexers connected to the remote control panel. The channel LEDs will
light up sequentially while the search is in progress. (See
page 11 for panel diagram.) The LED corresponding to each responding
multiplexer(s) will flash. The remote control panel will continue searching for
connected multiplexers until no further responses are received from any connected
device.
62
Front Panel Controls
on
Appendices