Part Names; Installation - U.S. Jaclean VITALITY STEP Quick Start Manual

Part Names

Ti m e S p e e d
F a t t e s t i n g / M o d e
Reset
Ti m e M o d e
S p e e d u p Speed-down
Accessories
Screws for Footplate
• M5x14 screws (2)
• M5 lock washers (2)
• M6 lock washers (2)
• M8 washers (2)
• Knobs (2)
•
4
Control Panel
Armrest
Upper Stand
Decorative Cover
Lower Stand
Footplate / Base
Resistance Bands
Pedestal Cover
Adjustable Feet
Screws for Armrest
• M6x35 screws (2)
• M8x20 screws (2)
• M6 washers (2)
• M8 lock washers (2)
• Knob pin (1)

Installation

IMPORTANT! Please perform the following steps in the order described
below. Failure to do so could potentially make the product unusable.
1. Remove all protective wrapping from the unit's
parts. Unscrew the two bolts on the bottom of the
Control Panel. Install to the Tube seen in Figure 2.
2. Grasp the cord attached to the Control Panel and
tuck it into one end of the Upper Stand. Fit the
Control Panel onto that end, making sure that it is
inserted all the way in. Use the two M5x14 screws
and 2 M5 lock washers to fasten the Control Panel
to the top end of Upper Stand
3.
Then use the two M8x20 screws, 1 M8 washer
and 1 M8 lockwasher to each screw. Fasten to
underneath overhang flange with handlebar
bracket pocket facing down.
3
4. Turn clockwise to lock the both Upper and Lower
Stand into position.
4
5. Draw out the cord from the bottom of the Lower
Stand.
5
6. Connect the modular plug to the jack on one end of
the Base.
6
5