Related Manuals for Geba Tronic Cody Universal 3
Summary of Contents for Geba Tronic Cody Universal 3
- Page 1 Cody Universal Assembly, connection and maintenance of the device may only be executed by personnel trained accordingly. At this the underlying national and local regulations have to be observed.
- Page 2 Cody Universal conveniently to your requirements. The Cody Universal 3 gives you the possibility of direct control of A LCD display shows you every programming step, including the # of a an industrial door control.
- Page 3 > 5 sec. pass code with which you replace the pass code which is located on the memory place 00. Only by this your Cody Universal 3 is protected against manipulation! TIPTOMATIC:...
- Page 4 RC transmitter Mounting instructions Program 2 Deleting of remote controls Interior mounting of the logic: Delete specific transmitter: 1. Put the screw-driver into the gap of the enclosure front, push the screw-driver up and open the enclosure. Press the button of the 2.
- Page 5 RC transmitter Program 1 Technical Data: Teach-in of remote controls Supply voltage: 20-28V AC/DC, 230-240 V AC Output: 250V AC 5A Connections: 1.5 mm² max. Make sure before the teach-in that the optional wireless module is plugged in firmly at the logic board. Ambient temperature: -20 °C to +60 °C Press the desired Put DIP 1 to...
- Page 6 Set all DIP to reader to ON Before programming your Cody Universal 3 with your personal codes, please check the faultless function of the appliance with the help of the factory‘s pass code 1234 and the button. Usually, any programming is made via your personal mastercode. In order to get familiar with that kind of programming, you start with the input of a new pass code, which replaces the one preset by the factory (1234).
- Page 7 * Note: You can enter up to 50 different pass on the memories 00-49! Cody Universal 3 The keys are distributed among three blocks with each 255 keys of on color. The blocks correspond to the first 3 DIP switches.
- Page 8 Keypad Keypad Program 4 Program 6 Changing the control time / Tiptomatic time Entering a pass code push Enter 8 digit sound signal push push mastercode 2x long Enter 4 or 5 digit push button pass code button button sound signal 1x long button push...
Need help?
Do you have a question about the Cody Universal 3 and is the answer not in the manual?
Questions and answers