Advertisement
M10
N o t e s
After finished, check the parts installation are fastness, complete and in correct
M6
Right side installation with the same way of left side .
position.
第 4 页，共 4 页
Step 5 : Get No.1 left side step
assembly ,install No.12 nylon clips
into the clips support of side
step ,install original car clip nut in
side step(original side skirt
position); align clip and
instillation holes of car
body ,adjust side step and car
body to overall coordinate ,pat
clip position,fit on side step and
Step 6: Fetch No. 10 M4*20
group bolt , screwing in
preassembly splicing nut,tighten
side skirt of side step ,total 8
positions ;
Step 7 : Take No.7 M10 flange
nut cooperate with No.6
10*32*3 flat gasket, to
preassemble M10*25T bolt at
the bottom of car body,fasten ,
total 2 position; Take No.8 M6
flange nut cooperate with No.6
6*22*2 gasket, to preassemble
M6*25T bolt ,fasten , total 2
position.
Step 8: Take left side step cover
plate,align clamping jaw and hole
location of main body(side
step) ,install correctly,then drive
No.11 4*12 self-tapping
screw ,fasten ,locking hole ,total
4 positions.(left picture only
show 2 places of locking
location ).
Step 9 ：Take fastened bolt and
snap button of step 1 which
take down from original vehicle
front and rear wrap
angle ,screwing in wrap angle of
side step ,fasten position and
Advertisement
