Advertisement
A s s e mb l y P r o c e d u r e
F r o m l e f t s i d e t o s t a r t
1
M6*25（2pcs）
M10*25（2pcs）
2
第 3 页，共 4 页
Prepare ：
original vehicle; take down
front and rear fastened bolt,
snap button and clip nut which
locate in wrap angle of side skirt
to reserve .
Install side step：
direction to rear , find the
second and third water pore
(circular hole) on the bottom of
Body panel ; take off two
rubber blanking cover.
3
Step 2 ：Take No.3 M10*25T
bolts,put in the second and
third water pore ,total 2 pcs;
Step 3: Take NO.4 M6*25T
bolts , put in the small square
hole which between the first
and second water pores, and
the hole which between the
M6*25（2pcs）
third and fourth circular hole ,
total 4 pcs .
Step 1: Remove side skirt from
Step 1 : From the front wheel
Step 4：Take No.9 splicing
nut , put in the snaps hole
which locate in 2-9 place,
ensure splicing tail is straight
down and fasten, total 8pcs ;
Advertisement
