Advertisement
INSTALLATION
1.
Connect the base to the shock-proof stand.
2.
Hand-loosen the base using the dial on the back to adjust its clearance, then slide
it over the installation surface and tighten it to secure. Use the small screw on the
bottom to tighten further.
3.
Connect the top of the bracket to the plastic shock-proof frame.
4.
Use the large screw button of the bracket to adjust the bracket angle and use the
small screw button on the frame to adjust the frame angle.
5.
Install the pop filter and sponge ball as shown below. Connect the audio cable and
route it through the shock-proof stand.
6.
After the microphone is installed and connected, plug the audio cable to the
computer.
Advertisement
