Maintenance - HAUL MASTER 60438 Owner's Manual & Safety Instructions

Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY:
Remove load from Lift Table before service. Lower table when possible before service.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general condition
of the tool. Check for loose hardware, misalignment
or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other
condition that may affect its safe operation.
2. For convenient storage, the handle can be folded
down. To do this, press down on the Locking Bar
(117), then press down on the Handle (101).
Note: The Table (141) must be completely
lowered before folding down the Handle.
3. For best service, keep your Hydraulic
Cart clean and in good condition.
4. Store your Hydraulic cart in a location
where it is protected from moisture, dirt
and corrosive atmosphere. Protect it from
being damaged from other items being
moved in and out of its storage area.
Item 60438 For technical questions, please call 1-888-866-5797.
5. Occasionally apply light grease to the hinge
points of the Scissor Arm Assembly (151)
and other pivot points of the assembly. Wipe
off excess grease, as this will attract dirt.
6. Do not overload this cart, as that may cause
damage to the seals. If the Table will not raise, or
slowly lowers, the cause may be damaged seals or
low hydraulic oil level. To fix this condition, first try
the purging technique discussed on page 5 of
this booklet. If that doesn't work, take the Hydraulic
Table Cart to a qualified technician for repair.
7. Occasionally check the condition of the wheels.
They should be kept free of grease and oil, which
may damage the rubber tires. Occasionally add
grease to the grease fittings on each wheel.
8. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Page 7