Advertisement
OPERATION
•
When set to ON the light will illuminate continuously at approx 120 lumen. No dimmer
function is used.
•
When set to AUTO on first operation the light remains off until you place a finger
across the two contact sensors then the light will illuminate.
•
Longer touch will increase the light until maximum 120 lumens is reached.
•
A further longer touch will slowly reduce the light output to a minimum of 10 lumens.
•
When the light output is as you require, stop touching the sensors.
•
A brief touch across the sensor will turn the light off and a further brief touch will
restore the light output to the level as last set.
•
The lens can be rotated 40 degrees each way from centre to adjust the beam angle.
MAINTENANCE
•
Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
SPECIFICATION
Power supply:
Function:
Working time:
Charging time:
Material:
Light Source:
Output power high/low modes:
Product weight:
Product size H x W x D:
IP rating
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
1×Polymer Battery (1000mAh) internally sealed
Dimmable & Memory Lighting
3-80 hours
2-3 hours
ABS, PS
8×SMD2835 LEDs
10-120 lumen
145g
45×306×32mm
IP20
Made in China. PR2 9PP
Man Rev 1.0
Advertisement
