SNOWJOE sunjoe SPX4000-PRO Operator's Manual page 9

Fig. 8
(FRONT)
Water inlet
(female coupler)
Garden hose adapter
(female coupler)
Garden hose This end to the
(male end)
water inlet on
the unit
Fig. 9
(FRONT)
Garden hose adapter
(female coupler)
Garden hose
10. Attach garden hose to water supply (Fig. 10).
Fig. 10
Connect to water supply
Garden hose
m
WARNING!
Do not connect to potable water system.
m
WARNING!
If connection is made to a potable water
system, the system shall be protected against backflow.
m
WARNING
! The intake water temperature must
not exceed 104ºF/40ºC. The water supply must not
exceed 0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
11. Make sure the ON/OFF switch (pressure select dial) is
pushed to the STOP (0) position before plugging the unit
into the power outlet (Fig. 11).
Fig. 11
12. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you
may now plug the pressure washer into the power outlet
(Fig. 12).
Fig. 12
GFCI
Power light
indicator
9
STOP
0
Reset