Advertisement
4.5.
BATTERY CHARGER
4.5.1.
To remove the battery from the equipment, depress the spring loaded tab on the front of the battery pack. Remove the battery pack by
sliding it out. DO NOT touch the metal battery terminals.
4.5.2.
The battery is designed to fit into the charger one way only. Insert the battery fully and firmly to seat the battery into the charging base.
4.5.3.
Take the base charger and plug it into the mains, switch on the power and the LED on the charger will illuminate.
4.5.4.
When the battery is on charge the red LED on the charger will illuminate.
4.5.5.
When the green LED on the charger illuminates permanently the battery is fully charged.
4.5.6.
The battery has 3 LED charge level indicators that show full or partial charges levels.
4.5.7.
The battery charge state can be determined when not being charged by depressing the tab next to the LED display on the battery.
4.5.8.
Remove the battery from the charger. Switch off and remove the plug from the mains.
4.6.
BACKING PAD EXCHANGE (FIG.2)
WARNING: Remove battery before fitting / removing pads or maintenance is carried out.
‰
4.6.1.
First detach the removable handle by removing the two plastic screws on either side of the handle.
4.6.2.
To remove the backing pad, press down chuck locking button under the removable handle and manually unscrew the pad clockwise
(when viewed from above).
5. MAINTENANCE
WARNING! Before attempting any maintenance ensure the battery is removed from the unit.
‰
5.1.
Keep the machine clean and dry. DO NOT use abrasives to clean the unit. Ensure all external head screws are tight.
5.2.
Clean regularly by blowing a jet of compressed air through side vents to ensure motor ventilation is kept clear.
WARNING! Wear approved safety eye protection and, if necessary, respiratory protection.
‰
NOTE: The following maintenance must only be carried out by a technically qualified person or an authorised Sealey service agent.
On Off
Switch
Decrease
Speed
fig.1
© Jack Sealey Limited
Increase
Speed
Grip
Original Language Version
fig.2
CP18VOP Issue 3 (2) 20/07/20
Advertisement
