Hyundai MIG-160 User Manual page 10

08
6.4 MIG installation
1) Insert the welding torch into the "
Meanwhile, manually thread the welding wire into the torch body.
2)
en it clockwise.
3) Insert the quick plug of the wire feeder into the " +","g" ("GAS") on the mid-clapboard of the welding ma-
chine, and tighten it clockwise.
4) Install the wire spool on the spindle adapter, ensuring that the groove size in the feeding position on the
drive roll matches the contact tip size of the welding torch and the wire size. Release the pressure arm of
the wire feeder to thread the wire through the guide tube, and into the drive roll groove. Adjust the pressure
arm, ensuring no sliding of the wire. Too high pressure will lead to wire distortion, which will affect wire
feeding. Press the manual wire feeding button to thread the wire out of the torch contact tip.
5) Connect the cylinder equipped with the gas regulator to the gas inlet on the back panel of the machine with
a gas hose.
6.4.1 Sketch map of installation
HYUNDAI
" output socket on the front panel of the machine, and tighten it.
MIG-160/200
-