Advertisement
Use three screws to mount the small plate and
HDD to the base sheet of the inner cage.
Take the cardreader out of its cage and use two
small threads to fix it to the inner cage. Plug in the
USB cable to the cardreader.
The "Sens" connector is not needed, but the au-
tomatic front connector detection has to be deac-
tivated in Windows.
A HDD silent box can also be placed on top of the
inner cage if the TV card is not too long. But there
is only space for 1 single HDD or HDD silent box.
®
HFX
is a trademark of mCubed Information Technology GmbH. The design is patented. 3D Visuals and product design by 24H Product Design.
www.hifiatx.com - office@mcubed-tech.com - mCubed Information Technology GmbH - Mollardgasse 85a/3/136 - 1060 Vienna - Austria
10
9
Put the black plastik spacers on the screws for
the card reader.
11
12
Connect the front LEDs with the motherboard:
red front LED (yellow + / red -)
green front LED (black + / white -)
13
14
Put the inner cage back into the case and put the
acrylic glas on the optical drive. Make sure to fas-
ten the screw holding the small acrylic part on the
heatsink. Push the small acrylic part on the heat-
sink down while fastening the screw.
15
16
You can mount the backpanel first by letting a
distance for closing the lid. After closing the lid,
please tighten the 4 screws of the backpanel.
Advertisement
