Advertisement
Quick Links
HFX
micro M2 - Installation Guide
®
Please open first the 4 screws of the backpanel,
then you can lift up the lid.
and attach the heatpipe adapters to the outer
heatsinks.
Turn the base sheet of the cage with the drive
around, and use the two shorter M2,5 screws to
fasten the optical drive to the base sheet
For mounting the 2.5" HDD you have to prepare
the small plate with the hexagonal bolts. You
should use the longer bolts by standard. Only if
you want to install a thicker HDD, then please
use the shorter bolts. Use the counter sunk head
screws for fastening the hex bolts.
®
HFX
is a trademark of mCubed Information Technology GmbH. The design is patented. 3D Visuals and product design by 24H Product Design.
www.hifiatx.com - office@mcubed-tech.com - mCubed Information Technology GmbH - Mollardgasse 85a/3/136 - 1060 Vienna - Austria
1
2
Remove the DVD and HDD cage.
Lift and pull the base sheet.
3
4
Put the slim slot-in optical drive on the cage.
5
6
Screw the two longer M2,5 screws to the base
sheet, and use the nuts to fasten them They will
be used later to mount the card reader.
7
8
Place your Harddisk on the plate, on the side
without the hex bolts, and use the short screws
to fasten it. Depending what harddisk your are
installing different holes should be used.
Advertisement
Summary of Contents for Mcube HFX micro M2
- Page 1 micro M2 - Installation Guide ® Please open first the 4 screws of the backpanel, Remove the DVD and HDD cage. then you can lift up the lid. Lift and pull the base sheet. Put the slim slot-in optical drive on the cage. and attach the heatpipe adapters to the outer heatsinks.
- Page 2 Use three screws to mount the small plate and Put the black plastik spacers on the screws for HDD to the base sheet of the inner cage. the card reader. Connect the front LEDs with the motherboard: Take the cardreader out of its cage and use two red front LED (yellow + / red -) small threads to fix it to the inner cage.