Advertisement
4. opEration
Refer to fig.2.
4.1.
ensure that the vehicle being worked on is securely immobilised. if any wheels are removed it must be supported securely on
axle stands. neVer WorK under a VeHicle suPPorted By a JacK only.
4.2.
unfasten the webbing strap and roll the jack to immediately below the unit to be removed.
4.3.
using a ½" ratchet drive inserted into the drive socket, raise the saddle into light contact with the load.
Do not use an impact wrench with this product.
8
4.4.
The saddle may be tilted by up to 5° to allow better registration with the transmission unit being removed. Slacken the wing nuts on
both sides to allow adjustment of the saddle and re-tighten to lock in position. Do not attempt to adjust tilt whilst under load.
4.5.
secure the transmission unit to the saddle using the webbing strap and remove fastenings holding the transmission unit to
the vehicle. it may be necessary to maneouvre the jack gently to allow the fastenings to be withdrawn cleanly.
4.6.
When the transmission unit is free, reverse the ratchet to lower the saddle allowing removal from beneath the vehicle.
4.7.
it is recommended that, for maximum stability, the saddle is lowered fully before moving under load.
4.8.
re-installation is the reverse of the above procedure.
5.
maintenance
5.1.
Apply a good-quality grease periodically to all moving parts, paying particular attention to the lead screw (fig.2).
5.2.
replace the securing strap if it becomes torn or damaged in any way.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
Environmental protection
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
WarrantY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7ar
Original Language Version
fig.2
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
tJ150e | issue 2 21/12/16
Advertisement
