Sound And Vibration; Before Starting The Equipment - Bavaria BPO 1100 E Original Operating Instructions

Anleitung_BPO_1100_E_SPK1__ 03.01.14 12:18 Seite 11

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value a
h, DS
K uncertainty = 1,5 m/s 2
Operating mode: Sanding with sanding paper
Vibration emission value a
h, P
K uncertainty = 1,5 m/s 2
Operating mode: Polishing
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with another electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
5.1 Assembly (Fig. 3-6)
Important! Pull out the mains power plug before
starting the assembly work.
84 dB(A)
3 dB 6. Starting up
95 dB(A)
6.1 Using as a polishing machine
3 dB
When using waxing and polishing agents,
observe the instructions issued by their
manufacturer!
IMPORTANT!
To prevent damage to the surfaces of the workpieces
you wish to polish, make sure that you observe the
following instructions:
= 11,89 m/s 2
Make sure that the polishing attachment is always
n
mounted precisely in the center of the
sanding/grinding disk.
Before you start the equipment, check to ensure
n
= 13,35 m/s 2
that the attachments are securely installed.
Never touch the area you wish to polish with the
n
edge of the sanding/grinding disk.
Use the speed selector (Fig. 2/Item 4) to select the
n
following maximum speeds for polishing:
- Working in polish:
- Polishing to a high gloss: approx. 1000-1100 rpm
- Polishing up:
If you do not comply with these instructions, the
manufacturer cannot accept any liability.
The Velcro fastener enables easy changing of the
polishing attachment.
Use the foamed plastic attachment to apply the
polishing agent (Fig. 7).
n
n
n
n
n
n
n
Use the fleece attachment to finish off the
Make sure that the foamed plastic attachment is
free of any foreign bodies.
Spread the polishing paste evenly over the
polishing pad. Do not apply the polish directly to
the polishing surface.
Switch the polishing machine on and off only
when the polishing machine is resting on the
polishing surface.
Place the extension lead over your shoulder and
work first on the large, flat surfaces such as the
bonnet, boot lid and roof.
Keep your movements as regular as possible.
Important! Allow the polishing machine to glide
over the polishing surface. Do not exert pressure!
Work next on the smaller surfaces (doors, for
example)
GB
approx. 1000 rpm
approx. 1400 rpm
11