Table of Contents
Advertisement
Installation of the washing machine
Remove package
Remove package and take out the bottom board of
the cabinet on the foam cover.
Open the lid of washer's door and take out accessories.
A trial operation or washing on the foamed cushion is
strictly forbidden.
Installation of drain hose
Placement of water drain hose
Under 300cm
If the water drain hose shall
The placed height of water
be extended, its length shall
drain hose shall not exceed
not exceed 300cm,
15cm.
otherwise it will affect the
water discharging time.
Installation of base cover:
Step 1. Insert base cover into base slot
as below picture;
Step 2. Push base cover into proper
position;
Step 3. Press base in below direction
to snap four buckles into base;
Step 4. Use screw to fix base cover.
Base foamed cushion
Completely sleeve the drain
hose over the sewer.
Fix and tighten it with a hoop.
( As shown in the figure )
Under 15cm
Do not bend the water
drain hose and place
it under the washer.
Step 1
Step 2
Step 3
Step 4
5 5 5
Installation of the washing machine
Installation of water inlet pipe
2
1
Small ball
Push down the slide jacket
to expose the small balls and
enable separation of connector
socket from speedy connector.
4
A
not flat) and push it upward with force making the rubber
washer firmly press the plane center of water tap mouth.
5mm
Junk ring
B
Then tighten the screw sequentially. After that, tightly
screw on part B.
The connection socket
Connect: Push down the slide jacket
consists of A and B two
of speedy connector (4 small balls
parts. Before installation,
must be exposed ), insert it into the
A and B two parts must
connection socket and then push
be unscrewed about
upward Release the connection
5mm, or directly
of water tap with speedy connector
disconnected. If the
completely. If it is required to feed
6
bore of water tap is
water, simply open the water tap.
larger, remove the
Separate: Close the water tap, push
Connect
plastic junk ring of
down the slide jacket of speedy
part A.
connector and pull out the speedy connector.
Tightly screw another end of water inlet
hose on water inlet valve (with rubber
seal ring inside).
Note: When tightening the clamping nut,
evenly apply the force and do not twist
the water inlet valve to avoid breaking of
water inlet valve joint.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard. The instructions for appliances
connected to the water mains by detachable hose-sets shall
state that the new hose-sets supplied with the appliance are
to be used and that old hose-sets should not be reused.The
openings must not be obstructed by a carpet.This appliance
is for indoor use only.
3
Unscrew four screws of part A
and sleeve part A horizontally
5
over the mouth at the end of
water tap (the mouth at the end
of water tap must be flat and
smooth. Flatten it by filing if it is
7
Separate
Water inlet hose
Clamping nut
6
6 6 6
Hide quick links:
Advertisement
Table of Contents
