Larson Electronics DCP-25-3XDP-6FT Instruction Manual

3 Plug Multiport AC to DC transformer converts 120-277 volt AC to 12/24 Volts DC
Thank you for your purchase of the Larson Electronics DCP-25-3XDP-6FT.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
•
RELEVANT LOCAL BUILDING CODES.
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL
•
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
•
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
WARNING:
USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE.
CORD IS INTENDED TO ALLOW OPERATORS TO EXTEND POWER TO EQUIPMENT WHEN STATIONARY OUTLETS ARE NOT
READILY AVAILABLE.
IMPROPER USE OF THIS CORD, PLUG, AND RECEPTACLE CAN LEAD TO SERIOUS INJURIES OR DEATH TO
PERSONNEL.
PERIODIC INSPECTION OF THE CORD IS NECESSARY.
THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY ARE FOUND,
THE CORD MUST BE REPLACED BEFORE RESUMING USE.
The DCP-25-3XDP-6FT from Larson Electronics is a Waterproof Power Supply that converts commonly used 120 - 240 V AC electrical
current to 12 V DC @ 25 Amps. This converter includes a typical straight blade plug on the input end and three 6' output whips
terminated in 2-prong Deutsch connectors. This unit takes voltages within the 100-277 V AC range and reduces it to 12/24 V DC,
allowing users to use standard AC power to operate equipment like our LED light bars and HID Golights that require low voltage DC
current.
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 100V - 277V AC, 50 or 60Hz except those
factory ordered with low voltage 11V to 25V AC/DC.
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown in the
diagram 
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take
connections if installed in a location where water may come in contact with the unit.
Ensure the unit is properly grounded and that wiring is done according to all local and
national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a location
where water may come in contact with the unit. All outdoor installations and
indoor installations near a wet location require the use of a GFCI device for safety,
according to the National
.
properly grounded
Larson Electronics, LLC
25 Amp Max - 6' Output Whips
Instruction Manual
precautionary steps
Electrical Code® (NEC).
Phone: (800) 369-6671
for weatherproofing all
Ensure the unit
Fax: (903) 498-3364
DCP-25-3XDP-6FT
is
www.larsonelectronics.com
THIS LINE
1 of 2