Retul Müve SL Build Instructions

Retül Müve SL Kit Build Introduction
Thank you for purchasing the Retül Müve SL dynamic fit bike.
Use these instructions to aid in assembling your new fit bike.
The Member's Area of www.retul.com is a great resource to gather informational documents and view
instructional videos for the Müve SL fit bike. The videos include:
- A thorough walkthrough of the assembly of the Müve SL fit bike
- Overview on the accessories included with your Müve SL such as the Stack and Reach ruler.
The Retül Müve SL is adjusted through the use of drive screws. Each full turn of a knob (large or small) will yield
a move of 2.5mm.
The optional fit-crank is attached via a standard square-taper bottom bracket.
Included is a loop of chain and master link sized for a 53T chainring and the included 20T freewheel. The chain
should be set to the proper tension using the tension screws, similar to a horizontal dropout single-speed
bicycle.
The Müve SL is required to have the rear wheel attached to a full stand trainer/resistance unit and not intended
to be used (i.e. a rider in the saddle) without the rear wheel attached to trainer stand. Instability and injury can
occur if the Müve SL is not properly set up.
Page 1 of 8