Electrolux EW2F4822AB User Manual page 22

22 www.electrolux.com
2. Press
• The appliance starts the
countdown.
• The door locks, the display shows
the indicator
• When the countdown is
completed, the programme starts
automatically.
You can cancel or change
the set of the delay start
before you press the
cancel the delay start:
12.7 The AutoSense System
load detection
After touching the Inicio/Pausa
button:
1. The AutoSense System starts
estimating the weight of the load to
calculate the real programme
duration. During this phase the dot
flashes on the display.
2. After about 15-20 minutes new cycle
duration is displayed.
The appliance automatically adjusts
the programme duration to the load
to achieve perfect washing results in
the minimum possible time.
12.8 Interrupting a programme
and changing the options
You can change only some options
before they operate.
1. Press
The indicator flashes.
2. Change the options.
3. Press
The programme continues.
:
.
• Press to set the
appliance to pause.
• Press until the
display shows
• Press again to
start the programme
immediately.
.
again.
12.9 Cancelling a running
programme
1. Turn the programme knob to position
deactivate the appliance.
2. Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
. To
'.
12.10 Opening the door when
the delay start operates
While a delay start operates, the
appliance door is locked and the
indicator
1. Press
The indicator
2. Wait about 2 minutes until the door
lock indicator
goes off.
3. You can open the door.
4. Close the door and press the
again.
The delay start continues to operate.
12.11 Opening the door when
the programme operates
While a programme operates, the
appliance door is locked and the
indicator
1. Turn the programme knob to position
2. Wait for some minutes and then open
the appliance door.
3. Close the appliance door.
4. Set the programme again.
to cancel the programme and to
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
is on.
to pause the appliance.
starts flashing.
stops flashing and
is on.
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
to deactivate the appliance.