MOOSE Z900 Quick Start Manual

MOOSE Z900 CONTROL PANEL

ARMING

Arming the System Prior To Leaving:
1. Verify that the READY indicator is on.
2. Enter your User Code.
3. The control station will begin beeping and the red ARMED indicator will blink to indicate that
arming will take place after the exit time expires. (The ARMED indicator will light steady after the
system arms.)
4. Leave the building immediately.
Arming the System Without Leaving:
Turning off the Interior Zones and Entrance Delay:
Control station key 4 may be used to turn the interior zones off prior to arming. This will allow the
system to alarm instantly if the entrance door is opened, while armed.
1. Press the 4 key and hold three seconds.
2. When interior defined zones are turned off, the corresponding Zone indicators will flash. The
flashing will stop 30 seconds after the system is armed.
3. Arm the system by entering your User Code.
*Note: upon disarming, the interior zones automatically re-enable unless your installer has altered
this feature through programming.
Automatic Interior Off/Delay Off:
Your system may have been programmed to automatically turn the interior zones off if you arm
and do not leave the premises before the exit delay time expires. The entrance delay may also be
programmed to automatically turn off at this time. When the system is disarmed, the interior and
delay will return to their normal on or off state. See your security representative for details.
Two digit Arming:
Your system may have been programmed with an abbreviated arming feature. When this feature
is enabled, only the first two digits of your User Code will be required to arm the system and
perform other functions. Disarming however, will still require the entire code sequence.

DISARMING

Disarming Upon Entering The Premises:
*NOTE: If your system has the "Interior Follower" feature enabled, all interior designated zones
automatically become delay zones whenever you first enter through a delay zone. This allows
you to walk in front of motion detector on the way to the control station after you enter.
1. After entering the premises through a delay zone, the control station will sound a continuous
tone to remind you to disarm the system.
2. Enter your User Code.
3. The red armed light should turn off indicating that the system is disarmed.