Crye Precision LVS BASE VEST Operator's Manual page 4

This manual must be carefully read by all persons who have or will have the
responsibility for using or maintaining this product.
Any warranties made by Crye Precision LLC with respect to this product are voided if the
product is not used and maintained in accordance with the instructions in this manual. For any
questions relative to the use or repair of this product, please write Crye Precision LLC or call
1-718-246-3838 during regular business hours.
The following are general safety warnings intended to call attention to fundamental performance
limitations and areas of the product where proper usage must be followed. Failure to use and maintain
the product according to the instructions and warnings contained herein may result in the product
failing to perform as designed, and/or the persons relying on this product sustaining serious personal
injury and/or death.
• This product contains integrated ballistic
resistant regions.
• This product is designed to protect the wearer
only against the ballistic threat level stated in
the Product manual. It is not intended to protect
against rifle fire or sharp edged or pointed
instruments unless specified on the armor.
• Ballistic resistant regions are not intended to
protect the wearer from projectiles that hit
less than 1 inch from any edge of the ballistic
resistant regions.
• Exposure of the internal ballistic materials to
water, chemicals, or sunlight will reduce the
effectiveness of the armor.
• This armor is not flame resistant unless specified
elsewhere in this manual.
• Product that shows no signs of damage must be
replaced 5 years from date of purchase.
• Perform periodic inspections of the ballistic
resistant regions of the armor. Discontinue use
of damaged product immediately.
• DO NOT machine wash or dry clean the product.
Exposure to detergents, bleach, or solvents
may result in degradation and reduce the
effectiveness of the product.
• Inspect the product for discoloration, cuts, tears,
abrasions or cracks before and after each use.
• DO NOT alter the product in any way.
• DO NOT expose the product to open flame or
excessive heat.
• All replacement parts must be acquired from
Crye Precision LLC or a licensed distributor.
• The most current version of this manual may be
found at www.cryeprecision.com.
• DO NOT use this product except in its intended
manner.