Related Manuals for Thermomedics Caregiver PRO-TF Series
Summary of Contents for Thermomedics Caregiver PRO-TF Series
- Page 1 Professional Clinical Thermometer ™ With TouchFree Technology PRO-TF SERIES PRO-TF300 Instructions For Use Copyright© 2021 Thermomedics All Rights Reserved...
- Page 2 1. Low battery indicator 2. Date indicator 3. Date/Time 4. Temperature reading 5. Body temperature indicator 6. Object surface temperature indicator 7. Room temperature indicator 8. Memory mode 9. Error warning 10. Temperature unit ˚F/˚C...
-
Page 4: Intended Use
Features • Fast measurement that meets ASTM and ISO standards • Simple 1-button operation, no scanning required • No cross-contamination and may be used on sleeping patient • Audible and visual indication of completed temperature • Backlit LCD display and Low Battery indication •... -
Page 5: Initial Setup
• Operating environment is from 50˚F to 104˚F (10˚C to 40˚C). • Do not expose to severe environments. Storage temperature is from -4˚F to 140˚F (-20˚C to +60˚C). • Do not use in presence of flammable anaesthetic mixtures. • Do not use on patients with scarred tissue or tissue compromised by skin disorders or trauma in the vicinity of the forehead measurement area;... -
Page 6: Body Temperature Measurement
Figure 2 Figure 3 Body Temperature Measurement About Body Temperature & Fever Body temperature can vary from one person to the next and also varies by location on the body and time of day. Temperatures measured from different sites, even at the same time, should not be directly compared. - Page 7 Inspect Sensor and remove any debris. Clean if necessary. Remove hair and perspiration from center forehead area. • If patient was lying face down or was wearing a hat or garment covering the skin, allow the forehead to be exposed to the air in the room for 5 minutes prior to taking reading.
-
Page 8: Temperature Recall
Temperature Recall If Caregiver® is powered off (blank display), press POWER. Press MEM button and hold. The date and a number from 1 to 30 will be displayed indicating the temperature number. “01” is the most recently taken temperature and “30” is the oldest. (After 30 temperatures are stored, the oldest will be deleted) Release the MEM button and the “TIME”... -
Page 9: Setting Date And Time
Room temperature mode measures the temperature of the room in which the thermometer is located. Allow 20 minutes for the thermometer to adjust to abrupt changes in room temperature. Setting SURFACE or ROOM Modes 1. If Caregiver® is powered off (blank display), press POWER. 2. -
Page 10: Maintenance And Cleaning
Press SET to change the HOURS and toggle AM/PM. The Press MODE repeatedly to increase the hours by 1 or press F repeatedly to decrease the hours by 1. 10. Press SET to change the MINUTES. The “minutes” digits 1. Press MODE repeatedly to increase the minutes by 1 or press F repeatedly to decrease the minutes by 1. -
Page 11: Troubleshooting Error Codes
HIGH Sensor Error Allow Caregiver® to equilibrate to or Ambient the current room temperature for 20 Temperature minutes. Contact Thermomedics® Unstable Support if this error persists. Body Mode Remove Sensor Lens cap. Allow Temperature patient to warm up in ambient... - Page 12 Displayed BODY Mode: ˚F to 108.0˚F (34.4˚C to 42.2˚C) Temperature Range SURFACE Mode: 32˚F to 140˚F (0˚C to 60˚C) Storage -4˚F to 140˚F (-20˚C to +60˚C) Pressure: 525 Environmental mmHg to 795 mmHg 15% - 95% Relative Range Humidity Operating 50˚F to 104˚F (10˚C to 40˚C) Environmental Range 15% - 85% Relative Humidity (non-condensing)
-
Page 13: Symbol Information
Symbol Information Seperate collection for electrical and Follow Instructions for use electronic equipment (WEEE) Manufacturer Storage temperature range Date of Manufacture Storage humidity limitation YYYY - MM - DD Non-ionizing Electromagnetic Radiation Keep dry Protection against vertically falling Fragile, handle with care water drops Authorized representative in the European Mark of conformity to European medical... - Page 14 P|14...
- Page 15 P|15...
-
Page 16: Warranty
For questions or warranty related service, please go to our web site at: www.thermomedics.com/contact and submit your question or email a technician directly at technical-support@ thermomedics.com. You may also leave a message for technical service at 1-800-208-3009 ext 300. Please register your Caregiver® Thermometer via our web site at: www.thermomedics.com/register...
Need help?
Do you have a question about the Caregiver PRO-TF Series and is the answer not in the manual?
Questions and answers