Advertisement
Quick Links
Advertisement
Related Manuals for CONTACLIP TTPCard
Summary of Contents for CONTACLIP TTPCard
- Page 1 TTPCard Thermal transfer printer TTPCard User manual...
-
Page 2: Cleaning Kit
• As much as possible, avoid the ingress of environmental contamination, eg dust, into TTPCard. • Always fi t the protective cover when TTPCard is not in use, particularly in a dusty environment. • Do not insert sharp, hard or pointed objects (e.g. screwdrivers, rulers or knives) into the front aperture of TTPCard, otherwise the print head may be irrevocably damaged. - Page 3 TTPCard will also reproduce Clipart images, drawings, barcodes and bitmaps down to very small sizes. Compact, ergonomic, clean and quiet TTPCard may be conveniently located in an office, like any other peripheral. Each monochrome ribbon can print more than 300.000 PC-...
- Page 4 Carry out the following procedure step by step: Connect the cables • Connect the USB cable between the PC and the USB socket (7) on the rear of TTPCard. • Check the supply voltage is correct then connect the power supply cable between socket (8) on the rear of TTPCard.
- Page 5 3. Fit the printer ribbon on to the feed spindle (rear), locating the slot in the ribbon spool fully on to the key on the spindle. When viewed from the front of TTPCard, the key should be on the right hand side with the lead of the ribbon underneath, facing forward.
- Page 6 Mount the support templates Different templates are supplied with TTPCard suit the range of printable materials. Proceed as follows: • Select the template appropriate to the medium to be printed according to the table alongside. • Press the green button (4) to open the carriage.
- Page 7 4.6). • Position the sheet by hand such that the open ‘first’ row of tags/markers is nearest to TTPCard with the locating lugs on the underside of the sheet inserted fully into the corresponding holes in the template (See FIGS. B and C). Once loaded, the sheet must be flat, square, clean and without protrusions, lifted or bent components;...
- Page 8 • Switch the TTPCard OFF. • Switch the TTPCard ON and press the green button (4) for less than 6 seconds until the yellow LED (2) starts blinking. • Release the green button. The yellow and orange LEDs blink while the green LED remains lit...
- Page 9 Warranty The TTPCard is guaranteed for one year against inherent faults and defects. The print head is classed as a consumable and not covered by the guarantee. The guarantee is void if parts used are not CONTA-CLIP original ones.
-
Page 10: Fault Description
Green button (4): authorised user only TEST mode, accessed by pressing green button (4) for more than 6 seconds during the initial start-up cycle, is indicated by the yellow and orange LEDs blinking simultaneously. Inadvertent access may be cancelled by switching the TTPCard OFF and then ON again after a few seconds. - Page 11 Spacerplate of PET for CCI-PC-CTB 28037.0 DP-CCI-PC-CTB Spacerplate of PET for CCI-PC-ETB 28038.0 DP-CCI-PC-ETB Spacerplate of PET for CCI-PC-PSP 28039.0 DP-CCI-PC-PSP TTPCard Transport case 28002.0 TTPCard Transportkoffer Ribbon black 28010.4 Folie TTPCard BK Ribbon blue 28010.5 Folie TTPCard BU Ribbon red 28010.9...
Need help?
Do you have a question about the TTPCard and is the answer not in the manual?
Questions and answers