Berger & Schroeter 31440 Owner's Manual

Berger & Schroeter 31440 Owner's Manual

Atv/utv electric winch

Advertisement

Quick Links

General
General
Safety
Safety
Precautions
Precautions
General
General Safety
Safety Precautions
Precautions
WARNING:
WARNING:
FAILURE
FAILURE
WARNING:
WARNING: FAILURE
FAILURE TO
MANUAL
MANUAL
BEFORE
BEFORE
INSTALLING
INSTALLING
MANUAL
MANUAL BEFORE
BEFORE INSTALLING
INSTALLING OR
YOUR
YOUR
YOUR
YOUR WINCH
WINCH
WINCH AND
AND
AND SERIOUS
AND
SERIOUS
SERIOUS
SERIOUS OR
C C C C heck all safety and environmental conditions prior and during use.
Before use, ensure that you are familiar with all winching performance and operation such as speed & direction.
A wire rope should be replaced if it shows signs of excessive wear, broken wires, corrosion or any other defects.
The winches duty rating is S3 (intermittent – periodic)
If the winch fails to pull a load under normal conditions, stop the operation within 30 seconds otherwise motor
damage may occur.
Ensure that the winch is connected to the correct voltage of 12VDC only.
Check that the freespool shifter is in the "Engaged" position during and after use.
Remove the remote control from the winch when not in use.
Do not wrap the wire rope around the load and back onto it self. Always use a strap to ensure that the wire rope does
not fray or kink.
Keep hands and clothes away from the winch, wire rope, and fairlead during operation..
Never unplug the remote control and battery leads when winching a load.
To avoid insufficient power when winching a load, the vehicle should be running and in neutral.
When winching a heavy load, lay a heavy blanket or jacket over the wire rope near to the hook end
If excessive noise or vibration occurs when running, stop the winch immediately and return it for repair.
OWNER'S GUIDE
ATV/UTV
ATV/UTV
ATV/UTV
ATV/UTV ELECTRIC
TO
TO
READ
READ
AND
AND
FOLLOW
FOLLOW
TO READ
READ AND
AND FOLLOW
FOLLOW THE
OR
OR
USING
USING
OR USING
USING YOUR
OR
OR
OR FATAL
FATAL
FATAL
FATAL INJURY!!
INJURY!!
INJURY!!
INJURY!!
ELECTRIC
ELECTRIC WINCH
ELECTRIC
THE
THE
SAFETY
SAFETY
THE SAFETY
SAFETY INSTRUCTIONS
YOUR
YOUR
ELECTRIC
ELECTRIC
YOUR ELECTRIC
ELECTRIC WINCH
WINCH
WINCH
WINCH
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS IN
WINCH
WINCH
COULD
COULD
RESULT
RESULT
WINCH COULD
COULD RESULT
RESULT IN
IN
IN
THIS
THIS
OWNER
OWNER
OWNER' ' ' ' S S S S
IN THIS
THIS OWNER
IN
IN
DAMAGE
DAMAGE
TO
TO
IN DAMAGE
DAMAGE TO
TO

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 31440 and is the answer not in the manual?

Questions and answers

Summary of Contents for Berger & Schroeter 31440

  • Page 1 OWNER'S GUIDE ATV/UTV ELECTRIC WINCH ATV/UTV ATV/UTV ATV/UTV ELECTRIC ELECTRIC ELECTRIC WINCH WINCH WINCH General General Safety Safety Precautions Precautions General General Safety Safety Precautions Precautions WARNING: WARNING: FAILURE FAILURE READ READ FOLLOW FOLLOW SAFETY SAFETY INSTRUCTIONS INSTRUCTIONS THIS THIS OWNER OWNER OWNER’...
  • Page 2 The winch is rated for intermittent-periodic duty. The winch is not to be used to lift, support or otherwise transport personnel. A minimum of five (5) wraps of rope around the drum are necessary to support the rated load. The rated line pull of the winch must be powerful enough to overcome the added resistance caused by whatever the vehicle is stuck in.
  • Page 3 Winch Winch Winch & & & & Roller Roller Roller Fairlead Fairlead Mounting Mounting Winch Roller Fairlead Fairlead Mounting Mounting 1. It is very important that the winch shall be mounted on a flat hard surface in order to make sure the motor, drum and gearbox housing are aligned correctly.
  • Page 4 Handlebar Handlebar Remote Remote Control Control Mounting Mounting Handlebar Handlebar Remote Remote Control Control Mounting Mounting Handlebar mounted trigger switch can be operated without removing your hand from the grip. • It is recommended that the switch be installed on the left handlebar. A piece of electrical tape around the handlebar will help prevent rotation of mount on the handle bar.
  • Page 5 2). To disengage the freespool, turn the freespool shifter clockwise to the “Disengaged” position. Wire rope can now be free spooled off the drum. Maintenance Maintenance Maintenance Maintenance Wire Wire Rope Rope Replacement Replacement Wire Wire Rope Rope Replacement Replacement Before installing a new wire rope, wrap the end of the wire rope with tape to prevent fraying.
  • Page 6 Check Check System System Check Check the the System System Before using the winch, verify the following: 1) Wiring to all components is correct. All loose wires are tie wrapped tight. 2) There are no exposed wiring or terminals. Cover any existing terminal exposures with terminal boots, heat shrink tubing or electricians tape.
  • Page 7 Maintenance Maintenance Schedule Schedule Maintenance Maintenance Schedule Schedule Carry out all inspections listed below on schedule and inspections are divided into Daily, Monthly and 3 Monthly. Clean all connections because corrosion on electrical connections will reduce performance or may cause a short. Item Item Item...
  • Page 8 Trouble Trouble Shooting Shooting Trouble Trouble Shooting Shooting When the winch fails to operate after several attempts, or if there is any fault operation while winching, check followings. Symptom Possible Cause Remedy Cut circuit or loosing Check battery cable. Weak battery or insufficient power Recharge or replace battery Damaged over load protector Replace over load protector...

This manual is also suitable for:

31778

Table of Contents